SPEFORM Zirconium sand
SPEFORM zirconium sand is mainly made of zirconium silicate and is very heat resistant. Due to its significantly lower thermal expansion compared to quartz sand, zirconium sand is used as facing sand for cast iron and steel.
SPEFORM chromite sand
Moulding raw material mainly made from the mineral chromite and used for areas exposed to high thermal loads.SPEFORM iron oxide
Synthetic quality with high Fe2O3 content.
BETASET hardener
Methyl formate is a highly volatile ester, which in contact with air serves as a carrier gas for curing of Betaset resin-sand mixtures in seconds.
Active bentonite
Inorganic core and mould sand binder or bonding clay for semi- and fully synthetic sand process, both for dry and for wet casting.
Packaging: 25 kg sacks, loose in silo truck
Volclay bentonite
Natural American sodium bentonite for extremely high loads, especially in steel casting. Volclay-bonded mould materials are characterised by:
- minimum drying out
- low elastic recovery
- high dry strength
- top edge stability
- low tendency to erode
- high resistance to deactivation and scabbing
- very good thermal stability
- high sintering point
- low consumption
Packaging: 25 kg sacks, loose in silo truck
SPEFORM foundry gypsum plasters
SPEDUR is a plastic-modified hard gypsum plaster, preferably used to produce bearing sides and pattern plates with required large flask sizes on disamatic and jolt moulding machines.HELIODUR 40 is a hard plaster with low swelling. Mould sides made with it are very dimensionally accurate.
SUPRADURO is a selected alabaster moulding plaster for pattern plates with small flask size and for modelling.
Stored dry in sealed sacks or containers the plasters have a shelf life of 6 months.